Compare Equipment Go Back

988 XE Wheel Loader

Engine

Net Power - SAE J1349 538 HP - -
Engine Power - ISO 14396:2002 580 HP - -
Engine Model Cat® C18 ™ - -
Gross Power - SAE J1995:2014 588 HP - -
Rated Speed 1,700 rpm - -
Peak Power Speed 1,500 rpm - -
Emissions U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014 - -
Bore 5.7 in - -
Stroke 7.2 in - -
Displacement 1105 in³ - -
Peak Torque - 1,200 rpm - SAE J1995 2230 ft·lbf - -
Torque Rise 58% - -

Operating Specifications

Operating Weight 116362 lb - -
Operating Weight - Standard 116362 lb - -
Operating Weight - High Lift 119618 lb - -
Rated Payload - Standard (Quarry Face) 12.5 ton (US) - -
Rated Payload - Loose Material (Standard) 16 ton (US) - -
Bucket Capacity Range 4.7-13 m3 (6.2-17 yd3) - -

Transmission

Transmission Type Cat switched reluctance electric drive - -
Forward 1 (virtual) 4.3 mile/h - -
Forward 2 (virtual) 7 mile/h - -
Forward 3 (virtual) 13.8 mile/h - -
Forward 4 (virtual) 20 mile/h - -
Reverse 1 (virtual) 4.3 mile/h - -
Reverse 2 (virtual) 7 mile/h - -
Reverse 3 (virtual) 17.5 mile/h - -

Hydraulic System - Lift/Tilt

Lift/Tilt System - Circuit EH-Positive Flow Control, Flow Sharing - -
Lift/Tilt System - Pump Variable displacement piston - -
Maximum Flow at 1,400-1,600 rpm 153 gal/min - -
Relief Valve Setting - Lift/Tilt 4757 psi - -
Lift Cylinder - Bore 8.7 in - -
Lift Cylinder - Stroke 41.3 in - -
Tilt Cylinder - Bore 8.7 in - -
Tilt Cylinder - Stroke 27 in - -

Hydraulic Cycle Times

Rack Back 4.5 s - -
Raise 8 s - -
Dump 2.2 s - -
Lower Float Down 3.5 s - -
Total Hydraulic Cycle Time 18.2 s - -

Hydraulic System - Steering

Steering System - Circuit Pilot, load sensing - -
Steering System - Pump Piston, variable displacement - -
Maximum Flow at 1,400-1,600 rpm 71.3 gal/min - -
Steering Cut Off Pressure 4351 psi - -
Total Steering Angle 86° - -
Steering Cycle Times - High Idle 3.4 s - -
Steering Cycle Times - Low Idle 5.6 s - -

Air Conditioning System

Air Conditioning The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes. - -

Axles

Front Fixed - -
Rear Trunnion - -
Oscillation Angle 13° - -

Brakes

Brakes ISO 3450:2011 - -

Operator's Cab

ROPS/FOPS ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards - -

Service Refill Capacities

Fuel Tank 147 gal (US) - -
Cooling System - Jacket Water 30 gal (US) - -
Cooling Systems - Power Train 8 gal (US) - -
Engine Crankcase 16 gal (US) - -
Diesel Exhaust Fluid Tank 8.7 gal (US) - -
Transmission 16 gal (US) - -
Differential - Final Drives - Front 49 gal (US) - -
Differential - Final Drives - Rear 49 gal (US) - -
Hydraulic System - Implement/Steering 126 gal (US) - -
Note All nonroad Tier 4 Final/Stage V diesel engines are required to use: – The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less). – Cat engines are compatible with the following renewable, alternati - -

Sound Performance - Tier 4 Final / Stage V - Standard

Operator Sound Pressure Level (ISO 6396:2008) 72 dB(A) - -
Machine Sound Power Level (ISO 6395:2008) 109 dB(A) - -

Sound Performance - Tier 3 / Stage III - Standard

Operator Sound Pressure Level (ISO 6396:2008) 72 dB(A) - -
Machine Sound Power Level (ISO 6395:2008) 110 dB(A) - -

Dimensions (Approximate) - Standard Lift

Ground to Top of ROPS 13.8 ft - -
Ground to Top of Exhaust Stacks 14.8 ft - -
Ground to Top of Hood 10.9 ft - -
Ground to Bumper Clearance 3.1 ft - -
Rear Axle - Centerline to Bumper 10.5 ft - -
Front Axle Centerline to Bucket Tip 14 ft - -
Wheel Base 14.9 ft - -
Maximum Overall Length 39.3 ft - -
Ground to Lower Hitch Clearance 1.9 ft - -
Ground to Center of Axles 3.2 ft - -
Clearance at Maximum Lift 11.9 ft - -
B-Pin Height - Maximum Lift 18 ft - -
Maximum Overall Height - Bucket Raised 24.5 ft - -
Reach - Maximum Lift 6.5 ft - -
Note Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height. - -

Dimensions (Approximate) - High Lift

Ground to Top of ROPS 13.8 ft - -
Ground to Top of Exhaust Stacks 14.8 ft - -
Ground to Top of Hood 10.9 ft - -
Ground to Bumper Clearance 3.1 ft - -
Rear Axle - Centerline to Bumper 10.5 ft - -
Front Axle Centerline to Bucket Tip 15.3 ft - -
Wheel Base 14.9 ft - -
Maximum Overall Length 40.7 ft - -
Ground to Lower Hitch Clearance 1.9 ft - -
Ground to Center of Axles 3.2 ft - -
Clearance at Maximum Lift 13.3 ft - -
B-Pin Height - Maximum Lift 19.3 ft - -
Maximum Overall Height - Bucket Raised 25.8 ft - -
Reach - Maximum Lift 6.8 ft - -
Note Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height. - -

Dimensions - Millyard Linkage

Ground to Top of ROPS 13.8 ft - -
Ground to Top of Exhaust Stacks 13.8 ft - -
Ground to Top of Hood 10.9 ft - -
Ground to Bumper Clearance 3.1 ft - -
Rear Axle - Centerline to Bumper 10.5 ft - -
Front Axle Centerline to Fork Tip 16.5 ft - -
Wheel Base 14.9 ft - -
Maximum Overall Length 41.9 ft - -
Ground to Lower Hitch Clearance 1.9 ft - -
Ground to Center of Front Axle 3.2 ft - -
Fork Height with Level Arms 8.1 ft - -
Fork Top Clamp Opening 13.1 ft - -
Fork Height at Maximum Lift 17.2 ft - -
Hinge Pin Height at Maximum Lift 16.1 ft - -
Dump Angle at Maximum Lift -39.4 ° - -

Buckets

Bucket Capacities 4.7-13 m3 (6.2-17 yd3) - -

Sustainability

Recyclability 96% - -
Add a Similar Product: