Engine meets Tier 4 Final/Stage V emission standards.
U.S. EPA TIer 4 Final and EU Stage V emission standards or U.S. EPA Tier 2 and EU Stage II equivalent
-
Note
Net power advertised is the power available at the flywheel plus front drive implement pump when the engine is equipped with fan, air cleaner, muffler and alternator.
-
-
Maximum Gross Power - ISO 14396
110 HP
-
-
Rated Speed
-
1,800/min
-
Engine Power - ISO 14396
-
752 HP
-
Gross Power - SAE J1995
-
766 HP
-
Net Power - SAE J1349 - Standard Ambient
-
699 HP
-
Net Power - SAE J1349 - High Ambient
-
648 HP
-
Peak Torque - 1,200 rpm
-
2624 lb/ft
-
Torque Rise
-
18 %
-
Weights
Operating Weight
18102 lb
-
-
Buckets
Bucket Capacities
1.3-3.5 m3 (1.7-4.6 yd3)
8.6 m³ – 10.0 m³ (11.25 yd³ – 13.0 yd³)
-
Bucket Capacities - General Purpose
1.3-1.9 m³ (1.7-2.5 yd³)
-
-
Bucket Capacities - Light Material
2.5-3.5 m³ (3.3-4.6 yd³)
-
-
Sustainability
Recyclability
95%
-
-
Cab
ROPS
ISO 3471:2008
-
-
FOPS
ISO 3449:2005
-
-
Note (2)
The declared dynamic operator sound pressure levels per ISO 6396:2008*, when the cab is properly installed and maintained, is 77 dB(A).
-
-
Note (3)
The labelled sound power level for the CE marked configurations when measured according to the test procedure and conditions specified in 2000/14/EC (as amended by 2005/88/EC) is 103 dB(A).
-
-
Note (1)
Cab and Rollover Protective Structures (ROPS) are standard in North America and Europe.
-
-
Note (4)
*The measurements were conducted with the cab doors and windows closed.
-
-
Service Refill Capacities
Cooling System
5.7 gal (US)
54.9 gal (US)
-
Fuel Tank
43.6 gal (US)
294.3 gal (US)
-
Hydraulic System - Including Tank
25.9 gal (US)
-
-
Engine Crankcase
2.6 gal (US)
20 gal (US)
-
Hydraulic Tank
14.5 gal (US)
-
-
Transmission
0.8 gal (US)
29.1 gal (US)
-
Note
DEF used in Cat SCR systems must meet the requirements outlined in the International Organization for Standardization (ISO) standard 22241-1.
All nonroad U.S. EPA Tier 4 diesel engines are required to use only Ultra Low Sulfur Diesel (ULSD) fuels containing 15 ppm (mg/kg) sulfur or less. Biodiesel blends up to B20 (20% blend by volume) are acceptable when blended with 15 ppm (mg/kg) sulfur or l
-
Axles - Front Center Differential
2 gal (US)
-
-
Axles - Rear Center Differential
2 gal (US)
-
-
Diesel Exhaust Fluid (DEF) Tank
4.8 gal (US)
-
-
Differential - Final Drives - Front
-
71.6 gal (US)
-
Differential - Final Drives - Rear
-
68.9 gal (US)
-
Hydraulic System Factory Fill
-
210 gal (US)
-
Hydraulic Tank - Implement and Hydraulic Fan
-
68.9 gal (US)
-
Hydraulic Tank - Steering and Braking
-
34.9 gal (US)
-
Steering
Maximum Working Pressure - Steering Pump
2683 psi
-
-
Steering Articulation Angle - Each Direction
40 °
-
-
Steering Cycle Times - Full Left to Full Right - At 2,350 rpm: 90 rpm Steering Wheel Speed
3.2 s
-
-
Maximum Flow - Steering Pump
17 gal/min
-
-
Number of Steering Wheel Turns - Full Left to Full Right or Full Right to Full Left
3.75 turns
-
-
Loader Hydraulic System
Hydraulic Cycle Time - Dump, at Maximum Reach
1.4 s
-
-
Hydraulic Cycle Time - Total Cycle Time
12.5 s
-
-
Maximum Working Pressure - Implement Pump
3408 psi
-
-
Relief Pressure - Tilt Cylinder
4931 psi
-
-
Hydraulic Cycle Time - Rackback
2.2 s
-
-
Relief Pressure - Tilt Cylinder - 3rd Function Maximum Working Pressure
3046 psi
-
-
Hydraulic Cycle Time - Raise, Ground Level to Maximum Lift
5.2 s
-
-
Relief Pressure - Tilt Cylinder - 4th Function Maximum Working Pressure
3046 psi
-
-
Maximum Flow - Implement Pump - 4th Function, Maximum Flow
24 gal/min
-
-
Maximum Flow - Implement Pump - 3rd Function, Maximum Flow
24 gal/min
-
-
Hydraulic Cycle Time - Float Down, Maximum Lift to Ground Level
3.7 s
-
-
Maximum Flow - Implement Pump
32 gal/min
-
-
Transmission
Note
*Creeper Control allows speed control from a stand still up to 10 km/h (6.3 mph). The Creeper Control will only work in Range 1.
Travel speeds based on Michelin 45/65R39 LD D2**L5 tires.
-
Forward and Reverse - Speed Range 3
25 mile/h
-
-
Forward and Reverse - Speed Range 2*
12.5 mile/h
-
-
Forward and Reverse - Speed Range 1*
6.3 mile/h
-
-
Transmission Type
-
Cat planetary power shift
-
Forward - 1
-
4.5 mile/h
-
Forward - 2
-
8.3 mile/h
-
Forward - 3
-
14.2 mile/h
-
Reverse - 1
-
4.9 mile/h
-
Reverse - 2
-
9.1 mile/h
-
Reverse - 3
-
15.5 mile/h
-
Direct Drive - Forward 1
-
Lock-up disabled
-
Direct Drive - Forward 2
-
8.5 mile/h
-
Direct Drive - Forward 3
-
15.2 mile/h
-
Direct Drive - Reverse 1
-
5.4 mile/h
-
Direct Drive - Reverse 2
-
9.6 mile/h
-
Direct Drive - Reverse 3
-
16.4 mile/h
-
Tires
Note (2)
In certain applications, the loader’s productive capabilities may exceed the tire’s tonnes-km/h (ton-mph) capabilities.
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 2.7 kg of refrigerant which has a CO2 equivalent of 3.861 metric tonnes (4.256 tons).
