Compare Equipment Go Back

6015 Hydraulic Shovel

General

Engine Output - SAE J1995 824 HP - -
Bucket Payload 16.1 ton (US) - -
Operating Weight 154.3 ton (US) - -
Note Specifications shown above apply to highly regulated, backhoe configuration. Lesser regulated and frontless configurations are also available. - -

Engine - U.S. EPA Tier 4 Final

Engine Model Cat® C27 - -
Gross Power - SAE J1995 824 HP - -
Net Power - SAE J1349 746 HP - -

Engine - Cat C27 with Tier 4 Final Emission Standards

Number of Cylinders 12 - -
Bore 5.4 in - -
Stroke 6 in - -
Displacement 1648 in³ - -

Engine - Equivalent to U.S. EPA Tier 2

Engine Model Cat® C27 - -
Gross Power - SAE J1995 839 HP - -
Net Power - SAE J1349 746 HP - -

Engine - Cat C27 with Tier 1 or Tier 2 Equivalent Emission Standards

Number of Cylinders 12 - -
Bore 5.4 in - -
Stroke 6 in - -
Displacement 1648 in³ - -
Aspiration Turbocharged and air-to-air aftercooled - -

Operating Weights - Backhoe

Operating Weight 154 ton (US) - -

Weights

Ground Pressure 23.6 psi - -
Note Operating weight includes: 700 mm (28 in) track shoes, 7.6 m (24 ft 11 in) boom, 3.4 m (11 ft 2 in) stick, standard rock bucket, 100% fuel and lubricants - -
Operating Weight 308000 lb - -

Track

Standard 28 in - -
Wide 36 in - -
Extra Wide 39 in - -
Number of Shoes - Each Side 46 - -
Number of Track Rollers - Each Side 9 - -
Number of Carrier Rollers - Each Side 3 - -
Track Pads Double grouser - -

Drive

Travel Speed - Two Stages - 1st Stage - Maximum 1.4 mile/h - -
Travel Speed - Two Stages - 2nd Stage - Maximum 2.1 mile/h - -
Maximum Drawbar Pull - Forward 192886 lbf - -
Maximum Drawbar Pull - Reverse 220987 lbf - -
Gradeability - Travel Drives Approximately 42% - -
Hydraulic Track Tensioning With accumulator - -
Maximum Drawbar Pull 179847 lbf - -

Service Refill Capacities

Fuel Tank 449 gal (US) - -
Cooling System 44 gal (US) - -
Engine Oil 23 gal (US) - -
Swing Drive 2.4 gal (US) - -
Hydraulic System - Including Tank 463 gal (US) - -
Hydraulic Tank 253 gal (US) - -
Grease Tank 18 gal (US) - -

Electrical System

System Voltage 24 V - -
Batteries 4 × 200 Ah (12 V each) - -
Alternator Rating 150 A (24 V) in total - -
Components (1) Emergency stop in cabin, engine module, pump room and on service station accessible from ground level - -
Components (2) Four maintenance free batteries - -
Components (3) Lockable battery isolation switch - -
Components (5) 14 LED high-brightness working lights - -
Components (4) 5 LED service lights - -
Components (6) 2 electric horns - -
Components (7) Two (2) lights for rear end - -
Components (9) One (1) beacon light on cabin roof - -
Components (8) One (1) light for machine deck/service - -

Hydraulic System

Main Pumps 3 × variable swash plate pumps - -
Main Pumps - Maximum Total Oil Flow 407 gal/min - -
Main Pumps - Maximum Pressure - Attachment 4641 psi - -
Pilot Pump 1 × gear pump - -
Pilot Pump - Maximum Flow, Pilot 40.4 gal/min - -
Pilot Pump - Maximum Pressure, Pilot 1378 psi - -
Main Pumps - Maximum Pressure - Travel 4641 psi - -
Swing Pump 1 × variable swash plate pump - -
Engine Fan Pump - Maximum Flow, Engine Fan 53.1 gal/min - -
Engine Fan Pump - Maximum Pressure, Engine Fan 3191 psi - -
Engine Fan Pump 1 × variable swash plate pump - -
Hydraulic Fan Pump - Maximum Flow, Hydraulic Fan 22.7 gal/min - -
Swing Pump - Maximum Flow - Swing 127 gal/min - -
Hydraulic Fan Pump 1 × variable swash plate pump - -
Hydraulic Fan Pump - Maximum Pressure, Hydraulic Fan 1958 psi - -
Swing Pump - Maximum Pressure - Swing 5294 psi - -
Hydraulic Oil Cooling - Maximum Flow 284 gal/min - -
Hydraulic Oil Cooling - Diameter of Fan 40 in - -
Filters (1) Full-flow high-pressure filters (200 μm) for main pumps - -
Filters (2) Full-flow filters (20 μm) for complete return circuit - -
Filters (3) Pressure filters (16 μm) for servo circuit - -
Filters (4) Full-flow filters (6 μm) for engine cooling return circuit - -
Filters (5) Swing charge filter (15 μm) - -
Filters (6) Pump case return screens (125 μm) - -

Swing System

Swing Drive Two (2) compact planetary transmissions with axial piston motors - -
Parking Brake Wet multiple disc brake, spring-loaded/hydraulically released - -
Maximum Swing Speed 4.9 r/min - -
Swing Ring Cross roller bearing with sealed internal gearing - -
Features (1) Closed-loop swing circuit with speed control - -
Features (2) Hydraulic braking of swing motion when control is returned to neutral position or by counteracting control for stronger braking - -
Features (3) All raceways and the internal gearing of swing ring supplied by automatic central lubrication system - -

Engine

Emissions U.S. EPA Tier 4 Final and EU Stage V; China Nonroad Stage III, equivalent to U.S. EPA Tier 2; Equivalent to U.S. EPA Tier 1 - -

Centralized Service Area

Feature Accessible from ground level - -
Equipped With (1) Emergency stop - -
Equipped With (2) Quick couplings for: Diesel fuel and Grease - -

Undercarriage

Travel Speed - Two Stages - 1st Stage - Maximum 1.6 mile/h - -
Travel Speed - Two Stages - 2nd Stage - Maximum 2.3 mile/h - -
Maximum Drawbar Pull - Forward 192886 lbf - -
Maximum Tractive Force 197157 lbf - -
Maximum Drawbar Pull - Reverse 220987 lbf - -
Gradeability - Travel Drives 38°/78% (SAE J1309) - -
Hydraulic Track Tensioning With accumulator - -
Number of Shoes - Each Side 46 - -
Number of Track Rollers - Each Side 9 - -
Number of Carrier Rollers - Each Side 3 - -
Components (1) Forged double-grouser track pads - -
Components (2) Chain links connected by hardened pins and bushings - -
Components (3) Postive Pin Retention (PPR2) sealed and greased track design - -
Components (4) All running surfaces of sprockets, idlers, rollers and track chain links hardened - -
Components (5) Fully hydraulic self-adjusting track tensioning system with accumulator - -
Components (6) Automatic hydraulic retarder valve to prevent overspeed on downhill travel - -
Components (7) Audible travel alarm - -

Operator's Cab

Components (1) Pressurized operator station with positive filtration - -
Components (2) Heated cab mirror - -
Components (3) Sliding upper door window (left-hand cab door) - -
Components (4) Glass-breaking safety hammer - -
Components (5) Removable lower windshield with in cab storage bracket - -
Components (6) Joystick Controls Alternate Patterns including ISO/JIS, BHL, MHI, KOBE, or SCM - -
Components (7) Beverage holder - -
Components (8) Literature holder - -
Components (9) AM/FM radio - -
Components (10) Radio with MP3 auxiliary audio port - -
Components (11) Two stereo speakers - -
Components (12) Storage shelf suitable for lunch or toolbox - -
Components (13) Color LCD display with warning, filter/fluid change, and working hour information - -
Components (14) Adjustable armrest - -
Components (15) Height-adjustable joystick consoles - -
Components (16) Neutral lever (lock out) for all controls - -
Components (17) Travel control pedals with removable hand levers - -
Components (18) Two power outlets, 10 amp (total) - -
Components (19) Laminated glass front upper window and tempered other windows - -

Automatic Lubrication System

Capacity - Grease Barrel 18 gal (US) - -
Type (1) Central bank lubrication system - -
Type (2) Grease is automatically applied to all attachment pivot points (except bucket linkage) and slew bearing - -
Type (3) Standard grease reel on machine for bucket linkage - -
Type (4) Grease refill service point accessible from ground - -

Attachments

Type (1) Boom and stick torsion-resistant with welded box design - -
Type (2) High-tensile steel with solid steel castings at pivot areas - -
Type (3) Boom and stick stress-relieved after welding - -
Type (4) Float valve for boom down function - -
Buckets Equipped With – Special liner material covering main wear areas inside and outside – Lip shrouds – Wing shrouds – Heel shrouds - -

Backhoe Attachment (BH) - Working Range

Maximum Digging Depth 26.3 ft - -
Maximum Digging Reach 45.6 ft - -
Maximum Digging Height 41.9 ft - -
Maximum Dump Height 27.9 ft - -

Backhoe Attachment (BH) - Digging Forces

Bucket Digging Force - ISO 120947 lbf - -
Bucket Digging Force - SAE 112600 lbf - -
Stick Digging Force - ISO 104761 lbf - -
Stick Digging Force - SAE 98800 lbf - -

Backhoe Attachment (BH) - Backhoe

Capacity 1:1 10.6 yd³ - -
Total Width 8.8 ft - -
Number of Teeth 5 - -
Tooth System Cat C70 or M75 - -
Weight - Including Standard Wear Package 18521 lb - -
Maximum Material Density - Loose 3030 lb/yd³ - -
Add a Similar Product:
  • 6030 Hydraulic Shovel Add
  • 6040 Hydraulic Mining Shovel Add
  • 6060 Hydraulic Mining Shovel Add
  • 6020B Hydraulic Shovel Add